DataLocker H100 Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penyimpanan DataLocker H100. DataLocker H100 12 halaman. Encrypted hard drive

GETTING STARTED

Before you can use your device, you must properly connect it to the computer. After you plug in a new device,

you must personalize it before you can use the authentication and private partition features. The device uses

pre-installed ACCESS Standard software to guide you through the personalization process. The personaliza-

tion wizard starts automatically when you plug in a new (or recycled) device. If auto-run is not configured for

your computer, you can start ACCESS Standard from the application partition on the device.

Depending on the power supplied by the host computer, you may require one or two USB connectors to use

DataLocker H100.

To plug in DataLocker H100 using one USB port

Plug the smaller (Mini-A) USB connector into the back of the DataLocker H100 device.

Plug the black Type A USB connector into the host computer.

Do not plug in the gray Type A USB connector.

If the yellow power LED flashes slowly, follow the procedure that uses two USB ports.

To plug in DataLocker H100 using two USB ports

Plug the smaller (Mini-A) USB connector into the back of the DataLocker H100 device.

Plug the gray Type A USB connector into the host computer.

Plug the black Type A USB connector into the host computer.

If the yellow power LED flashes slowly, the host computer does not meet the USB specification and

cannot supply the required power to the device.

Note 1: Plugging in the black USB connector first, followed by the gray connector, may delay the start up of

DataLocker H100 by a few seconds.

Note 2: If the yellow power LED flashes quickly, power detection has timed out. Remove all USB connections

and reconnect the cable.

The personalization process involves three main steps:

Applying a device profile—The profile sets default preferences for the device. You can choose the

Typical profile, with pre-configured device settings, or the Custom profile that allows you to configure

device settings. The Typical profile contains the following device settings:

• Authentication method: password authentication

• Number of device users: 1 (not including the Administrator)

• Private partition uses the total available disk space

• Minimum password length: 6

• Password Retry Limit: 10