AC autokraft TR-560 Buku Pegangan - Halaman 5
Jelajahi secara online atau unduh pdf Buku Pegangan untuk Skuter AC autokraft TR-560. AC autokraft TR-560 8 halaman.
Halaman Cetak
TYRE PRESSURES
Front and rear tyre pressures are
45psi or 3.1 bar. Pictures show front
and rear Schrader valve location.
Always check for wear and condition
of the tyres and replace if required.
BRAKE ADJUSTMENT
The brakes can be adjusted as a
normal bicycle. If the cable has
stretched, adjust at the brake caliper
first, then fine tune the adjustment at
the lever. Otherwise adjust at the
lever end. Check the brakes do not
bind after adjustment. The rear
brake is an optional extra.
WARNING: If the brakes are binding
they can overheat and cause brake
fade or failure. It can also cause
excessive wear on the transmission
and motor. If you are unsure of brake
adjustment take the TR-560 to your
local cycle retailer.
DRIVE BELT ADJUSTMENT AND
LUBRICATION
The drive belt can be checked by
twisting the belt at the centre point
between the two geared wheels
(electric motor and rear wheel tooth
drive). The correct tension is a twist
of 90°. If the drive belt requires
adjustment move the motor forwards
or rearwards by loosening the two
transmission bolts on either side of
the frame as indicated.
The drive belt needs to be lubricated
from time to time using a silicon or
lithium based grease. Ensure the
belt is free from dirt and debris
before lubrication.
Transmission bolts
WARNING: Ensure the drive belt
is
correctly
adjustment can lead to motor,
belt or wheel bearing failure. If you
are unsure of drive belt adjustment
take your TR-560 to your local cycle
retailer.
5
Transmission bolts
adjusted.
Incorrect