Elsner 10150 Deskripsi Teknis, Petunjuk Pemasangan - Halaman 12
Jelajahi secara online atau unduh pdf Deskripsi Teknis, Petunjuk Pemasangan untuk Pengontrol Elsner 10150. Elsner 10150 20 halaman. Radio control system
Juga untuk Elsner 10150: Operasi (13 halaman)
Halaman Cetak
4.3.4. Disassembling the wall bracket
4.3.5. Instructions for assembly and initial start-up
Never expose the sensor to water (e.g. rain) or dust. This can damage the electronics.
4.4. Installing the weather station
4.4.1. Installation position
Choose an installation position in the building where wind, rain and sun can be meas-
ured unhindered by the sensors. The weather station must not be installed underneath
any structural parts from which water can still drip onto the rain sensor after it has
stopped raining or snowing. The weather station must not be shaded by anything,
such as building structures or trees.
At least 60 cm of clearance must be left all round the weather station. This facilitates
correct wind speed measurement without eddies. The distance concurrently prevents
spray (raindrops hitting the device) or snow (snow penetration) from impairing the
measurement. It also does not allow birds to bite it.
Please take note that an extended awning does not shade the device from sun and
wind.
Temperature measurements can also be affected by external influences such as by
warming or cooling of the building structure on which the sensor is mounted, (sun-
light, heating or cold water pipes).
Solexa II Control • from software version 1.9
Version: 28.09.2016 • Technical changes and errors excepted.
12
Ill. 5
In the assembled state loosen the cover:
Using a small screwdriver lever carefully
in the groove. Remove the cover.
Installation/assembly