Cayken KCY-35QE Petunjuk Pengoperasian - Halaman 6

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian untuk Bor Cayken KCY-35QE. Cayken KCY-35QE 12 halaman.

Halaman Cetak

GROUNDING DEVICE

1.Avoid body contact with grounded surfaces such as pipes, radiators, ranges and

refrigerators.

2.Don't expose power tools to rain or wet conditions. Water entering a power tool with

increase the risk of electric shock.

WARRANTY

warrants this machine for a period of 6 months from the date of purchase

against defects due to faulty materials or workmanship and will repair without charge any

items returned. This warranty is void if the item has been damaged by accident or

unreasonable use, neglect, improper service, or other causes not arising out of defects in

materials or workmanship.

FAULT HANDING

FAULTS

Magnetic base

without suction

Machine did not

run after the jump

Magnetic little

suction

Turn the handle gu

ide does not work

Drill out the

elliptical hole

Spindle sway

Motor strike

Warning: magnetic drill equipped with a safety rope, when operating, make sure the

magnetic drill and the object is fastened by the rope.In case of power failure

suddenly, causing the machine fall off or thrown objects and cause accidents.

CAUSES

ELIMINATION METHODS

Switch contact undesirable

Repair the switch

Repair the power supply

Power supply is broken,Loose plug

The fuse burn out

Replace the Fuses

Repair or replace the magnetic bridge

Electromagnet short circuit or burn out

Adsorption not on the steel frame

Change the adsorption surface

Circuit board burn out

Change the circuit board

Repair and change switch

Switch contact undesirable

Check the electric drill part connector

Joint loose

Repair or replace the electric brush

Brush and commutator poor contact

Changing the armature or stator

Drill the armature or stator coil burn out

Adsorption artifacts thin

Replace the adsorption surface or thickening adsorption surface

Replace the adsorption surface or temporary welding

The adsorption surface is smaller than the

disk surface

thick surface adsorption

Support bar top tight

Support bar between the adsorption surface

The diode circuit board may damage the

Re Welding

original weld.

Shaft key cut

Replace the shaft key

Wheel and rack misplace

Unscrew the rack bottom screw, remove guide to repair

Correction of verticality tighten the fasteners

For a drill and a fastener is loose

Grind anew

Bit unilateral cutting

Adsorption surface have sundry

Eliminate clutter

Drill bit not concentric

Change bit

The frame adjusting screw is loose

Tighten adjusting screw

The spark color turns orange red

Feedrate slow down

Sparks fly out

Please change the brush

Spark into a ring fire

Please check if the motor is burnt out