Cayken KCY-36/2WDO Petunjuk Pengoperasian - Halaman 3
Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian untuk Bor Cayken KCY-36/2WDO. Cayken KCY-36/2WDO 13 halaman. Versatile magnetic drill
Juga untuk Cayken KCY-36/2WDO: Petunjuk Pengoperasian (8 halaman)
Halaman Cetak
Operation Manual
WARNING
To prevent electric shock or fire
,
please strictly abide by the procedures in the
operation manual
.
The machine only for the authorized persons
.
operate
If any violation of the instructions operation and cause personal injury
or machine damage
,
our company disclaim all responsibility
be
ed
The machine can
only maintain
by the people who has the certification
THANKS TO THE BUYER
Thanks for buying the series of magnetic drill
the operation manual and pay attention to the safety precaution.
The right operation, will make you fully feel our products superior performance.
Please put this manual in a safe place for future reference.
ABOUT THIS MANUAL
The machine model of the description in this manual:
KCY: 36/2WDO 48/2WDO 100/3WDO 130/3WDO 130/4WDO
KCY: 65/2WD
85/3WD
Confirm the machine model according to the nameplate.
,
please do not let other people to
.
.
machine
of
. Please read
Versatile Magnetic
Drill Oil Immersed
Versatile Magnetic Drill
DESCRIPTIONS OF PRODUCTS
Magnetic drill is a kind of electric tool for adhering and drilling on the horizontal level,side
face and top face,and widely used in the building,bridge building,and ship building industries
and so on.You can use the magnetic drill when you can not use drill press and electric hand
drill to drill huge steel workpieces or in field operation. It´s very convenient to use, flexible,
can reduce labor intensity, improve the machining precision and work efficiency.
CAUTIONS
1.Please read the manual carefully before use, to understand the magnetic base drill structure;
electromagnetic sucker, electric drill and transmission functions.
2.Before installing or remove the drill must confirm the motor switch is closed and unplug.
3.Using a drill bit after clamping, key wrench must be removed, while the drill must be sharp,
for Morse taper shank drill should pay attention to the flat iron tail at the cone sleeve waist
groove insert cone sleeve. Remove the drill, the inclined flat iron is inserted on the oblique
iron just bit dropping hammer sleeve waist groove.
4.And its operation must be put in the fuselage behind the cable, away from the drill bit
5.In the switching power supply, electric and magnetic switch must be in the off position
6.Drilling machine must be used when using engine coolant. The use of cooling liquid (soap)
according to the ratio of watered, absolutely can not direct use water cooling. Otherwise
very easy to damage, and the main internal rust on the drill bit can't get it out. No internal
machine water, otherwise it will burn the circuit board.
7.Such as the use of the stepless speed regulation, models of constant power overload prote
ction, the machine during use motor suddenly stop functioning, then in the function of over
load protection device, the steps are as follows: A.turn off the power switch, paused for a few
minutes; B.weight of the plug, then open the motor.
8.The use of magnetic base drill, must wear a seat belt buckle.
9.No rough operation personnel, feed can not handle in order to work fast and pressed down
the machine feed, so lossy bit and machine
10.Non-magnetic materials can not drill with magnetic base, if the non-magnetic material
punching need to choose the magnetic base drill with sucker.
11.Cannot use at the same time, electric welding machine and magnetic base drill on the same
piece of steel plate, so that the operating from electric shock danger.
1
2