Dust Care 4000 Quiet Series Panduan Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Penyedot Debu Dust Care 4000 Quiet Series. Dust Care 4000 Quiet Series 11 halaman. Central vacuum systems

Halaman Cetak
INDEX
GENERAL INFORMATION
PLANNING
Planning
Power Unit Location
Inlet Valves Locations
A word of caution
EXISTING CONSTRUCTION
Gaining acces to pipe run through carpeted floor
NEW CONSTRUCTION ROUGH-IN
Main system installation
Fully concealed installation
INSTALLATION OF A SUPERVALVE
Floor installation - Carpeting
New construction - Wall rough-in
New construction - Utility by-pass
Existing construction - Finished wall
Location for your Inlet Valve
Connecting to Mounting Plate
MOUNTING PLATE
Floor installation - Vinyl or Lino
Floor installation - Carpeting
New construction - Wall rough-in
New construction - Utility by-pass
Existing construction - Finished wall
Location for your Inlet Valve
Connecting to Mounting Plate
"DO-IT-YOURSELF" KIT
3
5
5
5
6
6
7
8
9
10
10
12
12
14
14
14
14
15
15
15
16
16
16
16
17
17
17
18
19
© Courtesy of Hayden Manufacturing Co. Ltd
Your machine
Model number:
Serial number:
Date of purchase:
GENERAL INFORMATION
Important electrical information
• Your central vacuum cleaner was designed to operate with
alternating current (110/120 V, 60 Hz).
• Connect your appliance on an electric circuit in compliance with the
specifications indicated on the vacuum cleaner nameplate.
• ATTENTION! Model 4000 operate with 220 volts (12 A).
Grounded for your safety
For your safety and protection, this central vacuum cleaner is equipped with a three-
prong plug on the power cord (see illustration). It must be plugged into a properly
grounded and polarized three-prong receptacle. If the receptacle you intend to use
will not accept the three-prong plug, or if you are not sure the receptacle is properly
grounded, you should have a properly grounded three-prongeg receptacle installed
according to the National Electrical Code by a qualified electrician.
DO NOT UNDER ANY
CIRCUMSTANCES BEND
OR REMOVE THE ROUND
GROUNDING PRONG FROM
THE PLUG IN ORDER TO
MAKE IT FIT A TWO-PRONG
RECEPTACLE.
3