Dust Free 19851 Panduan Pemasangan & Pengoperasian - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pemasangan & Pengoperasian untuk Pembersih Udara Dust Free 19851. Dust Free 19851 12 halaman. Bypass hepa /bypass hepa plus air cleaner

Halaman Cetak

DUST FREE

BYPASS HEPA / BYPASS HEPA PLUS INSTALLATION & OPERATION MANUAL

COLLAR MOUNTING INSTALLATION

Installing using the collar mounting

system in the return air plenum of the

forced air heating/cooling system is

another installation method. Use the two

field-provided, 8 inch round collars for

installation. See fig.3.

Install the return side connections after

the last branch on the return air plenum

and minimum two linear ft distance from

the furnace. Supplied with the unit is a 5-ft

power cord. If there is not a 120VAC outlet,

there will need to be one installed.

Note: The unit does not replace the filter

from the forced air heating/cooling system.

Regular maintenance of this filter is

necessary to permit the proper operation of

the forced air heating/cooling system.

WARNING

Electric Shock Hazard.

Can cause injury or death.

Electrical wiring of the unit to the

HVAC system should be done by a

licensed HVAC technician or

electrical installer.

WARNING

UV Light Hazard.

Can cause serious eye and skin

damage.

Do not look at UV-C light. Wear UV-C

eye and skin protection

NOTICE

Qualified Technicians Only.

This device is for residential

applications only and must be

installed in compliance with all

national and local electrical and

mechanical codes. Failure to do so

will void Dust Free® Warranty.

Fig. 3 Remote mount installation diagram.

• Find a location that satisfies both service

and maintenance requirements.

• Cut two 8-inch opening with metal

shears.

• Remove the door and filters and proceed

to cut the round precut metal tabs on the

top and bottom of the unit and remove

the insulation.

• Align the unit into the desired location

and then fasten the mounting bracket.

• Run approved ductwork to the HEPA and

fasten the round collars.

• Filters may be shipped in clear plastic

wrapping. If present, remove the

protective wrapping prior to turning the

system on. When installing the filters,

match the direction of filter flow to the

direction of air flow directed on the fan

housing.

• Place the access door back on the unit.

Insert the power cord into the receptacle

on the unit and plug into the wall outlet.