Dust Free 19300 Panduan Pemasangan & Pengoperasian - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pemasangan & Pengoperasian untuk Peralatan Pencahayaan Dust Free 19300. Dust Free 19300 13 halaman. Germicidal uv-c ultraviolet light
Juga untuk Dust Free 19300: Panduan Pemasangan & Pengoperasian (5 halaman)

Halaman Cetak

DUST FREE

LIGHTSTICK

UV INSTALLATION NOTES

•

Unintended use of the appliance or damage to the housing may result in the escape of

dangerous UV-C radiation. UV-C radiation may, even in small doses, cause harm to the

eyes and skin.

•

Appliances that are obviously damaged must not be operated.

•

The appliance must be disconnected from the supply before replacing the UV-C LAMP.

•

Doors and access panels bearing the ultraviolet radiation hazard label, which may have

UV-C SPECTRAL IRRADIANCE greater than 1.7 μW/cm2, are provided with an interlock

switch to interrupt the power to the UV-C LAMPS for your safety. Do not override. See

figure 3.

•

To comply with UL Standards, a magnetic switch must be deployed across all access

panels and doors that can expose an operator to more than of 1.7 μW/cm2 UV intensity.

•

To comply with UL Standards, a UV-C Radiation Hazard label must be placed on any

doors or access panels which can expose an operator to more than 1.7 μW/cm2 of UV

intensity.

•

Before opening doors and access panels bearing the ULTRAVIOLET RADIATION

hazard symbol for the conducting USER MAINTENANCE, it is recommended to

disconnect the power.

•

UV-C BARRIERS bearing the ULTRAVIOLET RADIATION hazard symbol should not be

removed.

•

Do not operate UV-C LAMPS outside of the appliance.

CAUTION

UV radiation hazard.

Disconnect power before

opening this access panel.

Follow operating

instructions.

AVERTIR

Risque de rayonnement UV.

Débranches l'alimentation

avant d'ouvrir ce panneau.

Suivre les instructions

d'utilisation.

WIRING AND TRANSFORMER INSTALLATION NOTES

This device requires a constant 24V-AC power source. It is recommended that the device

be powered by a dedicated, non-cycling, 40VA transformer. Cycling this UV light will void the

lamp's warranty and lessen the effective lifetime of the lamp. If powering from an existing

transformer already integrated on a furnace, air handler, or other appliance, an upgrade may

be required to the OE transformer. Ensure there is adequate volt-ampere (VA) capacity on

the existing transformer to support an additional 1.4A draw from this product

Verify the available volt amperes prior to connecting the UV fixture to the 24VAC circuit. Energize

all 24VAC components so they reach their maximum amp load (Straight cool system - activate

cooling. Heat pump - activate heating mode.)

After obtaining the available volt amperes, determine if the existing transformer can accommodate

a 1.4 amp load.

Beware that inadequate transformers may initially seem to power up the circuit only to then

overheat as a result of an overdrawing system.

After installing the UV fixture, energize all 24VAC components at their full amp draw, including the

UV fixture, and ensure that all systems are operational and that fuses remain intact.

If the SUPPLY CORD is damaged, it must be replaced by the manufacturer, its service agent, or

similarly qualified persons in order to avoid a hazard.

INSTALLATION & OPERATION MANUAL

Fig. 3 Disconnect power before opening any doors

or access panels bearing this label. See page 9.