Dust Free Bio-Fighter VersaLight 1SVL00 Panduan Pemasangan & Pengoperasian - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pemasangan & Pengoperasian untuk Peralatan Pencahayaan Dust Free Bio-Fighter VersaLight 1SVL00. Dust Free Bio-Fighter VersaLight 1SVL00 7 halaman. 1s and 2s ultraviolet light systems

BIO-FIGHTER® VERSALIGHT 1S, 2S INSTALLATION & OPERATION MANUAL
REMOTE LAMP MOUNTING
Remove the remote lamp housing from the
remote lamp base by removing the knurled
nuts. Then install the remote lamp base to the
surface with the includes mounting screws.
Using the remote lamp base as a template,
drill a 1" hole for the lamp. Repeat for the sec-
ond lamp base if applicable.
Fig. 2 Lamp is secured with a sliding bracket tightened with two
knurled nuts.
CAUTION
Sharp Edge Hazard.
Be careful of sharp edges on device and
HVAC equipment while installing the device.
Personal injury may result.
CAUTION
Clean lamp(s) prior to installation.
Failure to remove dirt and fingerprints from
the lamp(s) could shorten their lifespan.
WARNING
UV-C Light Hazard.
UV-C light can cause temporary or permanent loss of
vision, and sunburn. Take precautions to protect eyes
and skin from direct exposure.
(Fig.2)
4

INSTALLING THE LAMP

To maximize the efficiency and life of the UV-C
lamp, clean each lamp prior to installation.
Use isopropyl alcohol and cotton cloth to wipe
dust and fingerprints from the lamp.
Gently insert the lamp into the lamp hole.
Slide the bracket over the the retaining lip of
the lamp and tighten the two knurled nuts until
the lamp is securely fastened. The lamp seals
against the base of the unit using a rubber
grommet which prevents air leaks. Repeat for
each lamp of the installation.
Fig. 3 Lamp is secured with a sliding bracket tightened with two
knurled nuts.
REMOTE LAMP HOUSING
After lamp has been installed, reinstall the
remote lamp housing using the knurled nuts.
The remote lamp housing must be in place
prior to attaching the electrical harness.
Fig. 4 Reinstall lamp housing.
(Fig.3)
(Fig.4 )