Dust Free Biofighter XL 33 Panduan Pemasangan & Pengoperasian - Halaman 11
Jelajahi secara online atau unduh pdf Panduan Pemasangan & Pengoperasian untuk Aksesori Dust Free Biofighter XL 33. Dust Free Biofighter XL 33 13 halaman.
Halaman Cetak
BIO-FIGHTER
XL INSTALLATION & OPERATION MANUAL
®
TROUBLESHOOTING
Maintenance and troubleshooting should
be performed by a qualified technician.
Device fails to operate.
1. Check proper power is being supplied
to the device, and that the lamp lights
when unit is turned on.
2. Check that the lamp connector is
securely attached to the lamp.
3. Check that ballast is receiving correct
power. Replace ballast if necessary.
4. Check continuity of lamp filaments.
(Replace lamp if necessary.)
5. Check that wires are properly
connected to lamp and ballast.
LAMP REPLACEMENT
The lamp should be replaced annually
even if it appears to be operating normally.
UV-C energy production diminishes over
time.
1. Obtain the correct replacement lamp for
your model.
2. Disconnect power to the equipment.
Allow lamp to cool 10 minutes before
touching.
3. Disconnect the electrical connector to
the lamp and remove the lamp from the
lampholders.
4. Connect replacement lamp to
electrical connector and place lamp in
lampholders.
5. Reconnect power.
6. Verify operation.
WARNING
Burn Hazard. Can cause injury.
During replacement, allow lamps to
cool 10 minutes before removing.
Personal injury may result.
LAMP DISPOSAL
Dispose of UV-C lamp at your local
recycling center. You may also send your
UV-C lamp, in the same container you
received your replacement, to:
Dust Free® Reclamation
1112 Industrial Drive
Royse City, TX 75189
PROPER CLEAN-UP IN CASE OF
BREAKAGE
Wear protective gloves, eyewear and mask.
Sweep the broken glass and debris into a
plastic bag, seal the bag, and dispose of
properly.
Contact your local waste management
office for proper disposal.
Do not use a vacuum cleaner. Do not
incinerate.
REPLACEMENT PARTS
21" UV Lamp - #06180
33" UV Lamp - #06182
45" UV Lamp - #06184
61" UV Lamp - #06186
120V Ballast - #06192
230V Ballast - #06195
277V Ballast - #06193
WARNING
Mercury Hazard. Do Not Break.
UV-C lamp contains a small amount of
Mercury. May cause redness or
irritation. Manage in accordance with
disposal laws. www.lamprecycle.org