elsner elektronik 70391 Instalasi dan Penyesuaian - Halaman 8
Jelajahi secara online atau unduh pdf Instalasi dan Penyesuaian untuk Unit Kontrol elsner elektronik 70391. elsner elektronik 70391 18 halaman. Door operator control module
Halaman Cetak
2.3. Notes on mounting and commissioning
Device must not be exposed to water (rain). This could result in the electronics being
damaged. A relative air humidity of 95% must not be exceeded. Avoid condensation.
After the bus voltage has been applied, the device will enter an initialisation phase last-
ing a few seconds. During this phase no information can be received or sent via the
bus.
3.
Addressing of the device at the bus
The device is supplied with the bus address 15.15.250. You can program another ad-
dress into the ETS by overwriting the 15.15.250 address or by teaching via the pro-
gramming button.
Door operator control module KNX A3-B2 • Version: 17.12.2019 • Technical changes and errors reserved.
6
Fig. 3
4-wire connection line for binary inputs:
violet
yellow
white
black
Connection of the outputs independent from polarity.
Addressing of the device at the bus
input 1
input 1
input 2
input 2