Datalogic S70 Manual - Halaman 7
Jelajahi secara online atau unduh pdf Manual untuk Aksesori Datalogic S70. Datalogic S70 18 halaman. Advanced sensor with dual digital displays for use with plastic and glass fiber optic assemblies
Juga untuk Datalogic S70: Panduan Memulai Cepat (10 halaman)
Halaman Cetak
Dynamic TEACH and Manual Adjust
Moves switching threshold value up or down to make adjustments
•
Slide Mode switch to ADJ to enter Adjust mode
•
Press "+" to increase; press "-" to decrease
- GREEN display shows the switching threshold value
- 2 seconds after adjustment, GREEN display will flash 3 times to confirm
•
Slide Mode switch to RUN to complete operation
Remember: Manual adjustments are disabled when Auto Thresholds are ON
Follow these steps to perform a Dynamic TEACH:
NOTE: TEACH Selection must be programmed to dYn tcH (see
1. Enter Adjust Mode.
Method
SET Button 5
Remote Input 6
2. Enter Dynamic TEACH.
Method
SET Button
Remote Input
3. Present ON and OFF Conditions.
Method
SET Button
Remote Input
SET Button: 0.04 seconds "Click" 0.8 seconds
5
Remote Input: 0.04 seconds T 0.8 seconds
6
Action
Set Mode switch to ADJ
No action required; sensor is ready for
Dynamic TEACH method
Action
Click the SET Navigation key
Single-pulse remote input
Action
Present ON and OFF conditions
Present ON and OFF conditions
Program
Mode)
Display: Red - Signal Level;
Display: Flashes "dYn tch" then holds
on "1234 dYn"
T
Display: Red - Signal Level;
7
Result
Green - Threshold
Result
Result
Green - Threshold