Datalogic MEMOR 20 Panduan Memulai Cepat - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk PDA Datalogic MEMOR 20. Datalogic MEMOR 20 2 halaman. Vehicle dock
Juga untuk Datalogic MEMOR 20: Panduan Memulai Cepat (2 halaman)
Halaman Cetak
Battery Installation
1. Insert the battery pack into the slot, bottom first, and press it into place until it clicks:
Charging Instructions
The battery pack is not initially fully charged. After installing the battery, charge it with the USB Type-C or
with a dock (single slot dock, 3-slot dock, vehicle dock, 4-slot battery charger).
During the charging process the charging LED positioned at the top left side of the display glows red
constantly. Once the charging process has been completed, the charging LED glows green constantly.
Charge with USB
Use the provided USB Type-C cable in conjunction with the power supply adapter to charge the device
from a power outlet.
The charger is modular, with one adapter and five switchover plugs.
You can also use the USB cable to charge the Memor 20 from any self-powered USB hub or USB port on
a computer.
Use only a Datalogic approved power supply to power the Memor 20.
CAUTION
Charge with the Dock
Insert the device into the dock with the screen facing front and the head facing up.
Use only a Datalogic approved power supply to power any of the docks.
CAUTION
Do not put any foreign object such as, but not limited to, coins, paper clips, stickers inside the slot
of any of the docks.
Do not apply any sticker to the Memor 20 (see the examples below).
CAUTION
For information on the single slot dock/ 3-slot dock/ vehicle dock/ 4-slot battery charger refer to
the Quick Start Guide included in the dock' s box.
NOTE
The Memor 20 may get warm during charging. This is normal and does not mean a malfunction.
NOTE
SIM Card Installation
Memor 20 supports up to two nano SIM cards.
1. Turn off the Memor 20 or put it in swap battery mode (refer to the User's Manual for more details).
2. Press the battery latches and remove the battery pack:
3. Pull the rubber label to remove the SIM door, then open the SIM card tray:
4. Place the nano SIM card in the tray with the written part upward and close the SIM tray.
5. Replace the SIM door and press it.
6. Replace the battery (see
Battery
Installation).
Scanning and Imaging
2D Imager Data Capture
To scan a bar code symbol:
1. Point the scan window at the bar code.
2. Press one of the scan triggers. The imager projects a laser aiming pattern similar to those used on
cameras. The aiming pattern is used to position the barcode or object within the field of view.
3. Center the symbol in any orientation within the aiming pattern. Ensure the entire symbol is within
the rectangular area formed by the brackets in the aiming pattern, then either wait for the timeout
or release the Scan Key to capture the image. A red beam illuminates the symbol, which is captured
and decoded.
If the scan has been successful:
y If enabled, the good read beep plays.
y
y If enabled, the GreenSpot projects a green spot onto the bar code image.
y
y If enabled, the good read indicator positioned at the top left side of the display glows solid green.
y
Linear Bar Code
Relative Size and Location of Aiming System Pattern