CBC HSS-H37 Buku Petunjuk - Halaman 4

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Kamera Digital CBC HSS-H37. CBC HSS-H37 5 halaman. Security height marker camera

Halaman Cetak

1. UNPACKING

Unpack carefully. This equipment should be handled with care.

Check for the following items:

• Verify the unit model number.

• Verify that parts listed below have been included.

If an item appears to have been damaged in shipment, replace it properly in its carton and notify the shipper. If

any items are missing, notify your dealer or Sales Representative or Customer Service. The shipping carton is the

safest container in which the unit may be transported. Save it for possible future use.

Height Marker Camera

Hardware Kit

2 x Cable Ties

2 x Cable Tie Mounts

3 x Plastic Wall Anchor

3 x #8 cross recessed self-tapping screw, 1-1/2" length

1 x Barrel Plug Connector, 2.1mm pin, 36" length, stripped leads

1x Power Supply 120V to 12VDC 500mA

2. INSTALLATION

Tools required:

#2 Cross Recessed Screwdriver (Philips)

Level

Wire Splice and Crimper or Wire Nuts

Drill with 3/16" bit (Optional 1/8" bit)

Optional: Drill with ½" bit

Optional: De-burr tool

1. Choose desired location for camera installation. Verify mounting structure and

surface is capable of supporting the camera and no obstacle or interference is

present from existing installed devices or wiring.

2. Measure a distance of 5 feet from the finished floor height and mark vertical

location.

3. Mark centerline of horizontal location.

4. For plastic anchors, drill a 3/16" hole at intersection of the vertical and horizontal

marks. If the anchors are not being used, drill a 1/8" hole in mounting surface.

5. Install plastic anchor and #8 screw. Do not tighten.

6. Remove cover from Height Marker Camera by removing screw from top cover, then

slide cover up and lift.

7. Place center mounting keyhole in base over installed #8 screw. Level and align

camera base and frame.

8. Mark top and bottom mounting locations.

If wiring connection is being made through the back of the camera base frame.

Mark wire ingress location.

9. Remove camera base frame and set aside.

10. Drill 3/16" hole at mounting location marks and install anchors.

If wiring connection is being made through the back of the camera base frame. Drill

wire ingress holes.

11. Place base over installed #8 screw, tighten screw, install and tighten top and

bottom mounting screws.

Confidential

Page 4

Slide cover up

and lift to open

Slide cover down

and in to close