CBE Avida PC220-KT Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Panel Kontrol CBE Avida PC220-KT. CBE Avida PC220-KT 16 halaman.

FUNCTIONS

LEISURE BATTERY CHARGE (B2)

Through engine alternator: through separate relays when engine is on. The ignition electronically

controls the relays: parallel, fridge, awning light, etc.

Trough 240V mains power through battery charger.

Trough solar panel: through solar charge regulator.

MINIMUM VOLTAGE CONTROL (BATTERY PROTECTION)

The electronic battery protection device cuts off the 12V fuses when leisure battery reaches 10V and

disables: pump, lights, Multimadia and stove.

Symbol ref. 1 is the visual alarm signal.

It is possible to reactivate all fuses for one minute by pressing the on/off button (ref. 06 on control

panel).

The control panel automatically turns off with a voltage lower than 9.5V.

Fuses are automatically reactivated when voltage is greater than 13.5V.

This device doesn't control the functions: fridge, step and the auxiliary exit DIR.

ELECTRONIC BATTERY SEPARATOR

An electronic device controlled by the ignition switches on the batteries parallel when the chassis

battery voltage is over 13.5V and switches off when engine is off or voltage is lower than 12.2V. This

device operates only if the B2 leisure battery is connected.

This device controls the relays of the fuses depending from exit simulating +OUT D+ (3 way function

fridge, awning light, antenna motion, etc.).

DIGITAL CLOCK

To set clock see "SETTING".

AMPERE METER

The amperemeter is inside the DS520-AN module.

- It measures the current of the leisure battery, users' consumption and recharge through battery

charger, engine alternator and solar panels.

- Measurement range is: -40A ÷ +40A.

- Measurement is carried out as difference between charging and discharging currents: a positive value

indicates a charging current, a negative value indicates a discharging current.

To measure the charging of a sole source (battery charger, alternator or solar panels), turn off all

items and other charging sources.

To measure the consumption of a sole user, disconnect all charging sources and turn off all unused

items.

BROKEN FUSE ALARM

Under each fuse is positioned a red LED.

The lighting of the LED signals that the fuse is broken and it is necessary to replace it with another fuse

with the same value. The alarm is activated only when the control panel is on and the user related to

the fuse is switched on.

NOTE: before replacing the fuse find out the problem that determined the intervention of the protection

(blown fuse) and fix it, it may be necessary to have a qualified technician assist.