ADE EHR1 Panduan Pengoperasian - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Timbangan ADE EHR1. ADE EHR1 20 halaman. Platform scale

Risk of death from electric shock: Before wall mounting, make sure that

there are no pipes or lines at the drilling location.

Caution: Damage to property: Before wall mounting, find out which

mounting material is suitable for your wall. The supplied mounting material

is only suitable for mounting in masonry.

In any case, make sure that the display unit is installed vibration-free, dry

and protected against falling down.

Housing and ports

Connect the Platform to the Indicator.

Mains supply (1) as well as the serial port (2) is located at the right side of the ADE-EH housing.

Load cell connection is located at the bottom side of the housing.

Connection of a PC or printer is possible via SUB-D plug-in port (2).

The power supply is raised either by Standard Alkaline batteries, 4 x "AAA", (not included in

the scope of delivery) or through mains operation by the provided power supply unit. The

imprinted voltage value must be in conformance with the local voltage.

Connect the main cable at the plug-in point and connect the main plug with an electrical outlet.

When using the device battery operated and all numerals of the LC-display are flashing that

means the batteries voltage are under 4,9V. You should replace the batteries soon. If the

display indicates "Lo.bAt" the batteries voltage are under 4,7V. You should replace the

batteries immediately.

For energy saving the scale can be adjusted that in power supply by batteries the automatic

switch-off function can be activated.

It is not allowed using other mains adaptor than the enclosed one from the

manufacturer. Otherwise, there might cause the risk of interferences to other

electrical devices!

Make sure that the connecting cable between scale and mains adaptor do not

turn out to be a tripping hazard.

EHR_EHQ-210517-Rev009-UM-en

(1) (2)