Datamaster T0046 Panduan Pengguna - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kabel Jaringan Datamaster T0046. Datamaster T0046 19 halaman. Professional lan cable tester

Halaman Cetak

Datamaster

T0046 Professional LAN Cable Tester – User Guide

LAN MODE – MAIN TO REMOTE TERMINATOR

The Loopback mode is capable of testing for the following faults:

•

Open circuit

•

Short circuit

•

Crossed wires

Enter LAN Mode from either the main menu on the screen or by pressing the blue coloured

button.

LAN

Connect the cable between the MAIN socket and a Remote

Terminator as shown in the diagram opposite.

Press the

TEST

The display will indicate a PASS and the type of cable

connected if there is no fault.

If there is a FAIL due to a open-circuit fault, the distance to

the fault will be displayed.

Failures due to SHORT or CROSS problems will have the

applicable wire pair(s) shown).

The ID number of the remote terminator is displayed

TEST RESULTS

If the cable being tested was not faulty, the

display will show the type of cable (FTP or UTP)

the word PASS and the word REMOTE

(indicating the test was performed in Remote

Terminator Mode. An FTP cable will also show a

wire 0 for the shield connection in addition to the

1 – 8 data wires. The screen-shot shows the

result for a non-faulty FTP cable that was tested

with Remote Terminator ID #1.

If one (or more) pairs are open circuit, the

word FAIL is displayed along with the identity

of the open pair(s) (in this case, wires 3 & 5)

in blinking text. The distance from the MAIN

socket to the open circuit is also displayed (±

5% accuracy). Other wires will be displayed in

non-blinking text to indicate that they were not

faulty. The Remote Terminator ID Number will

be shown as "?".

button.

Page 7