CBT Supply FIK-19 Panduan Instalasi - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Perabotan Dalam Ruangan CBT Supply FIK-19. CBT Supply FIK-19 16 halaman. Flipit kit generation ii

Halaman Cetak

FIH Model:

Install Cable Release

If you are installing the FIH flipIT

Kit with no keyboard tray, the

template for pilot holes to install

a keyboard tray is not included.

There is no template for cable

release pilot holes. You will use

the cable release assembly itself

to determine pilot hole locations.

Installation tip:

If you are also installing a

3rd-party keyboard tray,

install that hardware before

installing the flipIT handle so

you can make adjustments

for handle placement.

Do not drill through the desk-

top! Use a depth gauge or

make one out of masking

tape. See page 8 Drilling

Pilot Holes.

The screw and locking nut ships installed on the lid ar m. Remove the locking nut,

place the cable release eyelet over the screw with the cable side of the fitting f acing

away from the lid ar m. Replace the locking nut. Tighten the nut, then back it off a

quarter turn so it moves freely.

To mark locations for drilling 5 pilot holes, pull the slack out of the cable and place

the bracket parallel with the lid. Mark hole locations with pencil.

Using 1/8" bit, drill pilot holes

using masking tape for a

depth gauge. With 5 wood

screws, install the handle

bracket.