Datamax I-Class Mark II Panduan Instalasi dan Penggunaan - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Penggunaan untuk Aksesori Printer Datamax I-Class Mark II. Datamax I-Class Mark II 12 halaman. General purpose input output (gpio) option
Juga untuk Datamax I-Class Mark II: Panduan Memulai Cepat (4 halaman)

Halaman Cetak

1. Installing the Option
2. Setup and Operation

Installing the Option

If the GPIO Card is already installed in the printer, skip this section and proceed to

"Configuring the Hardware". Otherwise, install the GPIO Card as described below:

A) Turn off and disconnect the power cord from the printer. Remove the three Screws

from the left side cover of the printer.

B) Open the printer's cover, loosen (do not remove) the two Screws on the inside of the

printer and lift the Cover Assembly up and off the printer.

Screws

Cover

Assembly

Screws