Datamax H-Class Manual - Halaman 9
Jelajahi secara online atau unduh pdf Manual untuk Pembaca kode batang Datamax H-Class. Datamax H-Class 14 halaman. Cutter option
Juga untuk Datamax H-Class: Manual (8 halaman), Panduan Memulai Cepat (12 halaman), Manual (10 halaman), Manual (12 halaman)
Halaman Cetak
Failure to properly configure the GPIO Port can result in damage to the printer and / or connected devices.
WARNING
Pin
Signal Name / Direction
1
+5 VDC
2
Input 6
3
Input 3
4
Output 6
5
Output 3
6
Ground
7
Input 5
8
Input 2
9
Output 5
10
Output 2
11
+24 VDC
12
Input 4
13
Input 1
14
Output 4
15
Output 1
[1]
Signal directions given relative to the printer.
[1]
Jumper
Position
Installed
JMP 11
Removed
N/A
N/A
N/A
N/A
Installed: Pins 1 – 2
JMP 7
Installed: Pins 2 – 3
Removed
Installed: Pins 1 – 2
JMP 4
Installed: Pins 2 – 3
Removed
Installed
JMP 10
Removed
N/A
N/A
N/A
N/A
Installed: Pins 1 – 2
JMP 6
Installed: Pins 2 – 3
Removed
Installed: Pins 1 – 2
JMP 3
Installed: Pins 2 – 3
Removed
N/A
N/A
N/A
N/A
N/A
N/A
Installed: Pins 1 – 2
JMP 5
Installed: Pins 2 – 3
Removed
Installed: Pins 1 – 2
JMP 2
Installed: Pins 2 – 3
Removed
GPI/O Port B Overview
Printer +5VDC is used (.5 amp maximum).
Note:
Drawing more than .5 amps can cause unreliable printer operation.
+5VDC must be supplied.
Programmed input function.
Programmed input function.
Programmed output function pulled-up to +5VDC.
Programmed output function pulled-up to +24VDC.
An external voltage via external pull-ups will determine this level, not exceed +30VDC.
Programmed output function pulled-up to +5VDC.
Programmed output function pulled-up to +24VDC.
An external voltage via external pull-ups will determine this level, not exceed +30VDC.
Printer chassis is used.
Ground must be supplied.
Programmed input function.
Programmed input function.
Programmed output function pulled-up to +5VDC.
Programmed output function pulled-up to +24VDC.
An external voltage via external pull-ups will determine this level, not exceed +30VDC.
Programmed output function pulled-up to +5VDC.
Programmed output function pulled-up to +24VDC.
An external voltage via external pull-ups will determine this level, not exceed +30VDC.
Printer +24 VDC (1.5 amp maximum).
Programmed input function.
Programmed input function.
Programmed output function pulled-up to +5VDC.
Programmed output function pulled-up to +24VDC.
An external voltage via external pull-ups will determine this level, not exceed +30VDC.
Programmed output function pulled-up to +5VDC.
Programmed output function pulled-up to +24VDC.
An external voltage via external pull-ups will determine this level, not exceed +30VDC.
7
Function / Description