Datapath VisionSC-HD4+ Panduan Pengguna - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kartu PCI Datapath VisionSC-HD4+. Datapath VisionSC-HD4+ 16 halaman. Audio and video capture card
Juga untuk Datapath VisionSC-HD4+: Panduan Memulai Cepat (2 halaman)

Halaman Cetak

Installing the Capture Card

You are likely to need a flat blade and /or a cross head screwdriver for the installation of the

VisionSC-HD4+ card; it would be useful to have these to hand before you begin.

•

Power down the PC (including peripherals), switch off at the mains and disconnect all the cables

connected to the computer, noting the positions for accurate reconnection

•

Remove the PC cover

•

Locate a vacant PCI Express slot (x4 or higher) on the motherboard and remove the blanking plate

(retain all screws)

If you are in doubt consult your motherboard documentation to correctly identify a PCI Express slot. If

the card is forced into a 32 or 64 bit PCI or PCI-X slot it will be irreparably damaged when the system is

powered up and the warranty will be

•

Reconnect all cables to the PC then connect input cables (not supplied) distributing the video source

signal to a connectors on the VisionSC-HD4+ capture card

•

Power up the PC and commence the software installation

How to Connect Input Sources

The VisionSC-HD4+ card has two DSM59 connectors, the connectors support DVI or HDMI using the

supplied splitter cables where required.

Care should be taken when connecting the splitter cables to the VisionSC-HD4+ card, there is no

requirement to force the cable into the connector. Forcing the cable into the connector could result in

damage not covered by the warranty.

void.

Fig.4