Datapath x Series Panduan Memulai Cepat - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Pengontrol Datapath x Series. Datapath x Series 17 halaman.

x-Series Quick Start Guide

STEP 3 CONNECT MAINS CABLE

When the power is switched on the multi-display controller will boot and

the LEDs on the front panel will flash for up to 15 seconds. Should the LED's

continue to flash see the troubleshooting section at the end of this guide.

MOD EL 1 7 5

MOD EL 17 5

MAD E IN E N G L AN D

MAD E IN E N G L A ND

U SB

1 0 0 - 24 0 V

1AMAX 5 0 \ 6 0H z

1 AMAX 5 0 \ 6 0 H z

Switch on

STEP 4 CONNECTING TO A PC

To successfully configure your multi-display controller, firstly install the Wall

Designer application on your PC by downloading the latest version from the

Datapath website www.datapath.co.uk.

L A N

When the controller has booted, connect it to your PC using the USB cable

provided. The controller is a plug and play device. Wall Designer will detect it

when the layouts are configured.

The multi-display controller can also be configured via a Network, (see Step 5).

1 A FUS E

1 A FU S E

Connect

Mains Cable

M OD EL 17 5

M O D E L 1 7 5

MA D E I N ENGL AND

MA D E I N E NGL A ND

US B

U SB

10 0 - 2 4 0 V

1AMAX 5 0 \6 0 H z

1 0 0 - 2 4 0 V

1 AMAX 5 0 \6 0 H z

USP Port

1 A F US E

1 A FUS E