Dux Platinum 3000 Series Panduan Produk - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Produk untuk Alat Listrik Dux Platinum 3000 Series. Dux Platinum 3000 Series 20 halaman. Pressure feed

Halaman Cetak

Operation Guide

The markings on the trigger yoke indicate

1.0mm of needle travel (e.g., a micrometer set-

ting of 1A equals 1.0mm of needle travel and a

setting of 2A indicates 2.0mm of needle travel).

NOTE: Maximum needle travel is 4mm,

making settings beyond 4A unnecessary.

Needle travel/fluid flow is not increased

beyond this point.

Changing Fluid Tips

Unlike other spray guns that require a matched,

or "lapped", set of needles and fluid tips, the

DUX Pressure Feed uses a standard universal

fluid needle. The needle does not have to be

changed when different fluid tips are installed,

and a new needle does not have to be purchased

with each new fluid tip.

Of course different coatings or coating applica-

tions may require different sized fluid tips. DUX

offers a range of tips from 0.4mm to 2.2mm

in .2mm increments. Due to the precision

machining of DUX parts, no gasket or o-ring is re-

quired between the tip and the fluid barrel.

To change tips, follow these instructions:

Ensure spray gun is depressurized.

Remove the air cap retaining ring and

air cap.

Pull the trigger to the rear.

Using the DUX 10mm fluid tip driver,

remove the fluid tip and inspect

threads for wear or contaminations

Install a new fluid tip and tighten using

the DUX 10mm fluid tip driver.

Replace the air cap and air cap

retaining ring

For customer service call 888.389.2732

PLATINUM PRESSURE FEED

IMPORTANT: To maintain the precise fit and

seal between the fluid tip and the stainless

steel fluid barrel, paint must not be allowed to

dry on the threads. The threads of both the

fluid barrel and tip must be thoroughly cleaned

after each use.

Fan Control Knob

The fan control knob is located on the top

front of the spray gun and is shown in Figure 6

be-low. This knob controls the amount of air

delivered to the horns of the air cap to shape

the spray pattern. The largest fan pattern is

achieved with the fan control knob pointing

toward the spray target—or the 12 o'clock

position. Spray pattern size decreases as the

knob is rotated in either direction from the fully

forward position. Minimum spray pattern size

is achieved with the fan control knob pointed

toward the rear of the spray gun—or in the 6

o'clock position.

12 O'Clock

6 O'Clock

Figure 6: Fan Control Knob

Page 8