4ms Sampler Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Perekaman 4ms Sampler. 4ms Sampler 20 halaman.

Halaman Cetak

Setting up your Sampler

1. Remove the Sampler from the box and anti-static bag.

2. Connect the larger end of the power cable to a 16-pin Eurorack power header on your power

supply distribution system, with the red stripe towards the -12V. The other end of the power cable

is a 10-pin connector which should be connected to the Sampler so the red stripe on the power

cable is orientated towards the bottom of the module (the bottom is marked by a white stripe and

"-12V"). Note: The Sampler is reverse-polarity protected, but other modules being incorrectly

connected could damage anything on the power bus.

3. Backup your microSD card before you first power the Sampler on! We recommend you

perform a full backup of the microSD card by using a computer (use the included SD card adaptor

if needed). This will be useful if the card ever becomes damaged or you wish to restore the

Sampler to the original factory settings and samples.

4. Securely screw the Sampler to the rails of your case. Power the system on.

5. When the Sampler first turns on, it will scan the SD Card for WAV files. The lights will flash purple,

yellow, and other colors. When the lights stop flashing and just the Bank light is on, the Sampler is

ready to play.

Never remove the microSD card when playing or recording!

Overview

• Up to 600 samples loaded at one time (10 samples per bank)

• Includes a microSD card with over 200 samples

• Extremely quiet, low noise and low jitter design

• Firmware can be updated by playing an audio file into the Sampler

Playback channel:

• Mono or stereo output through Out Left and Out Right jacks

• Play button/trigger jack: Tapping the button or receiving a trigger starts/re-starts the sample

When Length is set to "All", the Play button starts/stops the sample (set in System Settings

•

File, see page 15)

• Sample CV/knob: selects a sample from the bank

• Pitch CV/knob: playback pitch (-9 to +4 octave range)

Tracking: +/- 0.4cents over four octave range (C0–C3)

•

Pitch jack can be calibrated to an external keyboard or sequencer

•

• Start Pos CV/knob: position in the sample to begin playback (loop start point)

• Length CV/knob: playback time (loop end point)

Length knob at max: entire file is played

•

Length knob 50%-99%: 200ms - 5s of the sample is played (beginning at the Start Position)

•

Length knob <50%: Percussive decay envelope is applied to the playback (attack-only

•

envelope if playing Reverse)

Length <1%: Tiny grains are played (can be used to sweep through sample file data

•

manually)

• Reverse button/jack: toggles forward/backwards

• Bank button/jack: selects channel's bank

Tip: Hold Bank and turn the Sample and/or Length knob for fast selection of bank

• Reverse+Start Pos button/knob combo allows for setting volume of each channel

independently.

• Maximum file size for playback: 4GB per file (6.2 hours per file at 48kHz/16b/stereo)

Page