DV Mark Bad Boy 120 Panduan Pemilik - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat Alat Musik DV Mark Bad Boy 120. DV Mark Bad Boy 120 13 halaman.

Halaman Cetak
the highs need to be set a bit lower than the other channels, especially for soloing.
9) SOLO This 6 dB boost is activated by either a footswitch or the Smart Controller, and is optimized for notching up your volume for solos
during live performance. The SOLO control can only be engaged when the effects loop is active, since it's part of the effects loop circuit.
10) STANDBY Before powering on, make sure this switch is in standby position. When you turn on the power, the microcontroller waits for
the tubes to heat up before turning on the plate voltage. The "power on" LED will flash for 30 seconds before the amp is ready. When the LED
stops blinking, flip the standby switch to the ON position. Between sets or whenever you're on a break from playing, put the amp in standby
position (down).
11) POWER This switch delivers AC power to the amp. Make sure the unit is grounded; all three terminals of the AC power plug must be
connected to avoid any injury to the user or damage to the unit. DV Mark amps and combos are manufactured to be used in the country where
they have been sold, and are factory preset to that country's voltage. So make sure you're sending the correct voltage to your amp before you
connect it to AC power. Follow the procedure described in the STANDBY section above (10) before powering up your amp.
6
7
8
1
2
3
4
5
11
10
9
Triple 6
Bass
Middle
High
Input
Ch1
Ch2
0 dB
0
Max
0
Max
0
Max
-6 dB
Gain
Master
Presence
Bass
Middle
High
Bass
Middle
Ch3
0
Max
0
Max
0
Max
0
Max
0
Max
Gain
Master
Presence
Gain
Master
Presence
High
On
Solo
0
Max
Standby
Off
5