4ms Company WAV Recorder Panduan Pengguna - Halaman 15
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Perekaman 4ms Company WAV Recorder. 4ms Company WAV Recorder 15 halaman.
Halaman CetakElectrical and Mechanical Specifications
• 6HP Eurorack format module
• 0.98" (25mm) maximum depth
• 10-pin Eurorack power header
• Power consumption (maximums):
• +12V @ 112mA
• -12V @ 12mA
• +5V rail not used
OUT
• Audio
jacks
Frequency Response:
•
File:Out = +/-0.1dB max deviation at 20Hz - 20kHz
•
21V peak-to-peak = full scale
•
Up to +20dB digital gain can be applied while playing using Gain knob
•
IN
• Audio
jacks
Signal-to-Noise Ratio (SNR)
•
Measurements taken from recordings made in a typical Eurorack case, powered by a 4ms Row
•
Power 40 module:
-91.7dB @ 16-bit, 44.1kHz
•
-88.9dB @ 24-bit, 96kHz
•
Frequency Response:
•
Out:In = max +/-0.1dB from 20Hz to 15kHz. -0.5dB at 20kHz
•
20V peak-to-peak maximum before clipping
•
•
Up to +20dB digital gain can be applied while recording or monitoring using
• Record
jack
Incoming trigger starts/stops recording, or starts/re-starts playback
•
Trigger voltage must be > 1.6V, rising edge is detected
•
• microSD card slot accessible from front panel
Class 10 card included (16GB)
•
Jumpers
The PCB has one jumper labeled "JUMP", which fits on a 2-pin header
located at the bottom right of the PCB.
The jumper must be installed to enable the normalization of the Left IN jack to
the Right IN jack. If this jumper is missing, patching a signal into the Left IN
with nothing plugged into the Right IN jack will record silence on the right
channel.
The jumper should only be removed if you are connecting the WAV Recorder
to a 4ms Company Listen module. See the Listen manual for connection
details.
Page
15
of
15
Gain
knob