DV8 OFFROAD OE PLUS SRJK-09 Panduan Instalasi - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Aksesori Mobil DV8 OFFROAD OE PLUS SRJK-09. DV8 OFFROAD OE PLUS SRJK-09 4 halaman. Side steps 07-18 jeep wrangler jk 2-dr
Halaman CetakINSTALLATION
MANUAL
Begin by unpacking all items and inspecting
for missing pieces or damage. If you have any
concerns, please contact the company the
product was purchased from. Extra hardware
may be included with the product.
HARDWARE
INCLUDED
(4) M8x25 Hex
(8) M8 Nuts
(4) M8 Flat Washers (Wide)
(8) M8 Flat Washers
(12) M8 Spring Washers
STEP 1 |
Remove factory steps or
sliders, if equipped, prior to beginning
installation of DV8 OE Plus Side Steps.
On some vehicles, slight drilling may be
required to fit DV8 steps properly.
To determine if drilling is necessary, align
the slider with the vehicle and insert the
studs at the rear of the step into the holes
on the pinch weld.
Then line-up the middle and front studs
and check if they can be slid into place. If
the fitment is very close, a bit of force can
help manipulate the studs into place.
If they will not slide into place even with
some force applied, remove the sliders
and set off to the side to prepare for
drilling.
Note: Assistance is recommended to prevent
injury and damage to the product or vehicle.
NEED HELP?
855-680-9595