DVB LPBR-03 Panduan Instalasi - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Aksesori Mobil DVB LPBR-03. DVB LPBR-03 8 halaman. License plate bracket 2020+ ford bronco
Halaman Cetak
INSTALLATION
MANUAL
STEP 15
Partially remove a section of the weather-
stripping along the bottom of the trunk,
near to the driver side of the vehicle and
feed the wire through.
Replace the weatherstripping and all interior
trim panels when finished. Finish running
the wire behind the bumper to where factory
license plate light wiring is located.
STEP 16
Disconnect the battery to prepare for splic-
ing wires.
If you have a lot of excessive wire, trim it
to an appropriate length. Snip the factory
license plate wiring to splice the new license
plate wiring. If you wish to keep the quick dis-
connect wiring solution, be sure to cut the wires
after this connection, so that it will remain on
the vehicle. This will allow for easy connec-
tion and disconnection.
Reconnect battery when finished.
STEP 17
Finish securing spare tire carrier bolts se-
curing the license plate relocation bracket
using a 13mm socket. If you loosened bolts
to create clearance for the wire, re-tighten
these also with a 13mm socket.
BLACK TO BLACK
RED TO YELLOW
NEED HELP?
855-680-9595