Aussie Monsoon 100 Buku Petunjuk - Halaman 10

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mesin Cuci Tekanan Aussie Monsoon 100. Aussie Monsoon 100 16 halaman. Monsoon series

Halaman Cetak
Aussie Pumps

Instructions for use of grit blast kit

WARNING: To reduce the risk of injury, always
protect eyes and face with goggles and mask,
and hands and arms with heavy work gloves
when spraying abrasive materials.
1.
Connect lance of grit blast kit in to gun in place
of the vario lance.
2.
Place the sand probe in the sand container.
How To Sandblast :
1.
Connect and open the water supply line before
starting the pressure washer.
2.
Squeeze the gun trigger to release air in the
equipment.
3.
Turn on the pressure washer.
4.
Squeeze the gun trigger to activate the spray.
5.
CAUTION: Always test spray on a scrap of
similar material first! The high pressure spray
could damage the surface if the grit blaster is
held too close.
To determine best distance for grit blasting, start
with the spray nozzle a metre away from the
Recommended grit
Task
Paint from Metal
Paint from Masonry
Rubber Base Paint from Masonry
Paint from Wood (coarse, rough cut effect)
Paint from Wood (smoother, driftwood effect)
Metal Scale
Rust
Troubleshooting
No Sand
Not enough sand
Aussie Monsoon Single Phase Blasters ... Operation & Maintenance Manual
10
Sand Mesh
20/40
Round Silica i.e river sand
20/40
10/35
Angular i.e. crushed rock
40/60
20/40
20/40
16/50
Blocked sand probe.
Blocked nozzle.
Wet sand
Low vacuum
Incorrect water nozzle
Collapsed hose
Partial obstruction to sand probe
Low sand level
Low water pressure &/or flow rate
Sand probe
surface and gradually move closer, frequently
checking the surface for damage.
6.
Always point the nozzle downward when not
spraying. This prevents water from entering the
sand supply. If water does get into the sand
supply hose, remove the probe from the sand,
hold the gun trigger open, and let the hose air
dry. Always be sure the sand hose is dry before
using.
7.
Keep the sand covered to prevent the overspray
from wetting the sand. Do not allow small pieces
of the sand bag to fall into the sand supply. A
smaller piece could prevent the flow of sand.
Sand Type
Round Silica
Round
Round
Round
Angular
Clear obstruction and make sure air vents in
sand probe are open
Remove mixing nozzle and clean
Dry or replace sand
Valve open; air leaks in system. Tighten hose
clamps.
Change spray angle
Replace hose or remove restriction
Clear obstruction from sand probe inlet
Change probe to new bag of sand
See machine troubleshooting chart
March 2018
Connect to gun
Blasting Angle
0-30
0-20
0-15
1-10
1-10
0-15
0-25