AUSSIE TONNEAU ATB01097 Instruksi Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Instruksi Instalasi untuk Aksesori Mobil AUSSIE TONNEAU ATB01097. AUSSIE TONNEAU ATB01097 3 halaman.

2. CARING FOR YOUR TONNEAU

Apply bee's wax or Dri-lube to stitching a few times a year, as this will maintain the tonneau's

waterproofing ability and prevent the stitching from degrading. Use a mild detergent and soft

scrubbing brush to clean your tonneau cover.

Never drive without tonneau support bars in place as the flapping can cause a delaminating effect on

the material.

"Tonneau is not designed to be used as a load restraint"

3. MULTI-FIT SUPPORT BAR

The Aussie Tonneau Multi - Fit Support Bar is designed to fit almost all Utes on the Market, from

Suburu Brumbys to Cab Chassis aluminium trays.

3.1 BASIC TOOL REQUIRED

Drill, 4mm drill bit

3.2 MULTI-FIT SUPPORT BAR CONTENTS

- 1 x hollow bar centrepiece

- 2 x solid bar end piece

3.3 FITTING MULTI-FIT BAR

1. Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar bracket

holders with the holes facing to the ground (so the grub screws don't rub against the tonneau),

as shown above and then with a white pencil make a mark through the small holes of the

hollow bar onto the solid ends. This is where you will drill a hole to the depth of about 1-2mm

(do not go any further)

2. Join the pieces back together and screw grub screws through the hollow bar into the holes

that you drilled. Make sure you do not over tighten the grub screws. Refit the bar. You may

kink the bar in the middle to give it some extra height to assist with water runoff.

2 x grub screws