AUSSIE TONNEAU ATB01108 Instruksi Pemasangan - Halaman 3
Jelajahi secara online atau unduh pdf Instruksi Pemasangan untuk Aksesori Mobil AUSSIE TONNEAU ATB01108. AUSSIE TONNEAU ATB01108 3 halaman. For mitsubishi mn glxr triton dual cab with sport bar
3. MULTI-FIT SUPPORT BAR
The Aussie Tonneau Multi - Fit Support Bar is designed to fit almost all Utes on the Market, from Suburu
Brumbys to Cab Chassis aluminium trays.
3.1 BASIC TOOLS REQUIRED
Drill, 4mm drill bit
-
3.2 MULTI-FIT SUPPORT BAR CONTENT
-
1 x hollow bar centrepiece
-
2 x solid bar end piece
3.3 FITTING MULTI-FIT SUPPORT BAR
1. Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar bracket holders
with the holes facing to the ground (so the grub screws don't rub against the tonneau), as shown above
and then with a white pencil make a mark through the small holes of the hollow bar onto the solid ends.
This is where you will drill a hole to the depth of about 1-2mm (do not go any further)
2. Join the pieces back together and screw grub screws through the hollow bar into the holes that you
drilled. Make sure you do not over tighten the grub screws. Refit the bar. You may kink the bar in the
middle to give it some extra height to assist with water runoff.
-
2 x grub screws