AUSSIE TONNEAU ATB01233 Instruksi Pemasangan - Halaman 2
Jelajahi secara online atau unduh pdf Instruksi Pemasangan untuk Aksesori Mobil AUSSIE TONNEAU ATB01233. AUSSIE TONNEAU ATB01233 3 halaman. Tonneau cover for isuzu d-max my15-5 dual cab with headboard
Halaman Cetak
for the side rope buttons are all measured down from the TOP INSIDE EDGE of the tub. For the
rear button measure 160mm, 165mm for the second button from the rear, and 170mm for the
next two buttons. For the button closest to the front of the tub measure 175mm down and
25mm back from the front edge of the tub. Attach each bunji to the button as it is fitted.
NOTE: All measurements are to be taken from the TOP INSIDE EDGE of the tub.
10mm down
from top
edge of tub
2. CARING FOR YOUR TONNEAU
Apply bee's wax or Dri-lube to stitching a few times a year, as this will maintain the tonneau's
waterproofing ability and prevent the stitching from degrading. Use a mild detergent and soft
scrubbing brush to clean tonneau.
Never drive without tonneau support bars in place as flapping can cause a delaminating effect on the
material.
3. MULTI-FITT SUPPORT BAR
The Aussie Tonneau Multi - Fit Support Bar is designed to fit almost all Utes on the Market, from
Suburu Brumbys to Cab Chassis aluminium trays.
3.1 BASIC TOOL REQUIRED
Drill, 4mm drill bit
3.2 MULTI SUPPORT BAR CONTENTS
-
1 x hollow bar centrepiece
-
2 x solid bar end piece
"Tonneau is not designed to be used as a load restraint"
740mm
Place the bar bracket
with the beveled edge
facing up 740mm
-
2 x grub screws
Figure 1