Datavideo DAC-2 Panduan Pengaturan Cepat
Jelajahi secara online atau unduh pdf Panduan Pengaturan Cepat untuk Konverter Media Datavideo DAC-2. Datavideo DAC-2 6 halaman. Important note to make dac-2/dac-100 work with pinnacle dv500
Juga untuk Datavideo DAC-2: Panduan Instalasi (13 halaman), Panduan Tambahan (5 halaman), Panduan Tambahan (13 halaman)
Halaman Cetak
DAC-2 Quick Setup with Adobe Premiere 6.5 on Windows
This setup guide will cover four specific areas:
A. Explanation of front panel functions
B.
Verify which EPROM is in the DAC-2
C. Preview Monitor Connections
D. Initial Software configuration
A. Explanation of front panel functions
Button Functions
DV Input
The DV Button, has two functions:
Select/Reset
It selects DV as the input source and is also a reset.
Resetting the DAC-2 will put it into its default setting based on its Firmware version.
Composite
This button is for analog input source selection: Composite video (RCA), S-Video
Video, S-
(Y/C), and Y.U.V. (Component)
Video, Y.U.V.
12/16 bit
The A Encode button has two important functions; it selects the encoding audio
Audio/Mode
frequency between 12 bit (32 KHz) or 16 bit (48 KHz) and if it is held down for 3
Selection
seconds it switches modes.
B. Verify which EPROM is in the DAC-2.
On the underside of the DAC-2 there is a serial number sticker, which has a version number on it, the version
number is stamped or on a sticker.
Please find your version number in the table below: