Agri-Fab 45-0324 Panduan Pemilik - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penyebar Agri-Fab 45-0324. Agri-Fab 45-0324 12 halaman. Atv mounted 125 lb. broadcast spreader
Juga untuk Agri-Fab 45-0324: Panduan Pemilik (13 halaman)

Halaman Cetak
If you are using extension brackets:
6. Attach the extension brackets to the legs of the spreader
frame. Use two 5/16" x 2" hex bolts and 5/16" nylock
nuts per bracket. Tighten. See fi gure 4.
5/16" x 2"
HEX BOLT
5/16" NYLOCK NUT
FIGURE 4
If you are using extension brackets:
7. Attach the R.H. mounting bracket to the extension bracket
shown in fi gure 5 using two 5/16" x 1" hex bolts and
5/16" nylock nuts. Tighten. Repeat on the other frame
leg with the L.H. mounting bracket.
5/16" NYLOCK
NUT
FIGURE 5
EXTENSION
BRACKET
5/16" x 1"
HEX BOLT
MOUNTING
BRACKET, R.H.
8. Attach the spreader's mounting brackets to the vehicle's
rear rack using four 5/16" x 1-3/4" carriage bolts,
mounting clamps and plastic knobs. Use the adhesive
pads to protect the rack. See fi gure 6.
MOUNTING
BRACKET
FIGURE 6
9. Insert the 1/8" hairpin agitator into the middle hole in
the spreader shaft. Assemble a seal (turned as shown
in fi gure 7) onto the end of the spreader shaft closest
to the hairpin agitator. See fi gure 7.
10. Slide the end of the spreader shaft having the seal
through the plastic bushing in the bottom of the hopper.
See fi gure 7.
11. Slide the impeller onto the spreader shaft and secure
it with a 1/8" x 1-1/4" cotter pin. See fi gure 7.
1/8" HAIRPIN
AGITATOR
IMPELLER
1/8" x 1-1/4"
COTTER PIN
FIGURE 7
5
PLASTIC KNOB
MOUNTING
CLAMP
5/16" x 1-3/4"
CARRIAGE BOLT
ADHESIVE PAD
SPREADER
SHAFT
SEAL