DVIGear DVI-26xx-FO Panduan Memulai Cepat - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Kabel dan konektor DVIGear DVI-26xx-FO. DVIGear DVI-26xx-FO 4 halaman. Displayport v1.2 fiber optic cables
Halaman CetakDisplayPort v1.2 Fiber Optic Cables
1. DisplayPort Connector
2a. Lock Release Button
2b. Locking Mechanism
3. Copper Input / Output
4. TX / RX Module
5. Hybrid Optical / Copper Cable
Note 1: The transmitter and receiver modules have the same type of enclosure that includes an integrated
copper DisplayPort cable with a locking connector.
Note 2: WARNING: Take care that the cable is not forced to bend beyond its minimum bend radius.
Installation Instructions
The DVI-26xx-FO cable consists of a transmitter module (labeled "Computer") and a receiver module
(labeled "Monitor") integrated within the cable. The transmitter end must be connected to the output port
of a DisplayPort signal source (such as a PC). The receiver end should be connected to the input port of
a DisplayPort display or projector. This product may be connected to a Mini-DisplayPort source and/or
display using a DisplayPort Female to Mini-DisplayPort Male Adapter Cable (DVIGear p.n. DVI-8610a).
Note that the video signals in this cable travel over internal optical fibers and are UNIDIRECTIONAL. The
other signals (AUX Channel, HPD, power, etc.) travel over internal copper wires.
Note 3: WARNING: This cable will not function if it is installed backward. Always connect the transmitter end
(Computer) to the source device and the receiver end (Monitor) to the display.
1.)
Connect the transmitter end of the cable (labeled "Computer") to the DisplayPort source device.
2.)
Connect the receiver end (labeled "Monitor") to a display or projector.
3.)
This cable draws power from the connected DisplayPort source, which eliminates the need for
an external power supply.
4.)
Turn ON the Display, and then turn ON switchers and other distribution equipment (if used).
Finally, turn ON the source. Test the system to ensure proper performance.
Quick Start Guide
Connect the transmitter end to the source device;
Connect the receiver end to the display device.
Press to release locking mechanism on the connector.
Connector includes locking mechanism for added security.
The transmitter and receiver modules include an integrated 12"
copper DisplayPort cable.
Two electro-optical converters are integrated within the cable.
The DisplayPort signal is transported from the transmitter to the
receiver RX module over a hybrid optical / copper cable.
The minimum bend radius
Short Term: 75 mm / Long Term: 125 mm
DVI-26xx-FO
(2)
for this cable is as follows:
3