DVIGear HyperLight DVI-2300-AOC-RX Panduan Memulai Cepat - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Kabel dan konektor DVIGear HyperLight DVI-2300-AOC-RX. DVIGear HyperLight DVI-2300-AOC-RX 4 halaman. Dvi active optical cables

Halaman Cetak

1. DVI Connector

2. DVI Securing Screw

3a. Transmitter Docking Connector

3b. Receiver Docking Connector

4. Fixation Screw

5. Hybrid Optical / Copper Cable

Note 1: WARNING: Take care that the DVI Docking Connectors are used as shown. Mating the TX or RX cable

ends to the wrong docking connector could cause damage to the cable.

Note 2: WARNING: Take care that the cable is not forced to bend beyond its minimum bend radius.

Installation Instructions

If the cable must be pulled through a conduit or other tight space, please install the

cable pull cover using the two screws provided. After the cable pull has been completed,

remove this cover.

This cable includes two DVI docking connectors. One is labeled "Transmitter" on the front

side and "Source" on the back; the other is labeled "Receiver" and "Display." Connect the

TX end of the cable to the Transmitter docking connector, and the RX end of the cable to

the Receiver docking connector.

Connect the Transmitter / Source docking connector to a DVI source device (such as a PC).

Connect the Receiver / Display docking connector to a display or projector.

First, turn ON the Display and then turn ON any signal distribution equipment (if used).

Finally, turn ON the source device. Test the system to ensure proper performance.

Info 1: This cable requires very low power, which it draws from the connected DVI source. This eliminates the

need for an external power supply.

Info 2: This cable may be connected to an HDMI source and/or display using a DVI to HDMI Adapter Cable

(Model No. DVI-8511b or DVI-8511c).

Note 3: WARNING: This cable is UNIDIRECTIONAL and will not function if it is installed backward.

Always connect the TX end (labeled Transmitter / Source) to the source device and the RX end (labeled

Receiver / Display) to the display.

DVI Active Optical Cables

Quick Start Guide

Connect the Transmitter (TX) end to the DVI source device.

Connect the Receiver (RX) end to the display device.

Insert and tighten screws on the DVI connectors when mating

with the source and display units.

Insert TX side of cable into the docking connector labeled

Transmitter / Source. Secure with provided screw.

Insert RX side of cable into the docking connector labeled

Receiver / Display. Secure with provided screw.

Used to ensure the docking connector is secured to the cable.

The DVI signal is transported from the TX module to the RX

module over a hybrid optical / copper cable. The minimum

bend radius

DVI-23xxx-AOC

for this cable is 2 mm.

(2)

(1)