Austere 3S-12SP-50 Series Panduan Pengguna - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kabel dan konektor Austere 3S-12SP-50 Series. Austere 3S-12SP-50 Series 3 halaman. Banana adapters & speaker cable
Halaman CetakPrepping the Speaker Cable
After routing the cable, it's important to prepare it properly. Follow these guidelines:
1. Leave at least one to two feet of slack in the cable to avoid putting excessive pressure on
the cable or damaging your sound equipment when plugging it in.
2. Use wire cutters to clip the speaker wire to the desired length.
3. Separate the individual wires from the blue Precision Pull Marker by approximately six
inches. If desired, you can remove the excess Precision Pull Marker.
4. Use appropriate gauge wire strippers to strip away 5/8 inches of insulation from each end
of the cable. Each speaker should have a total of four wire ends prepped.
5. Once the insulation is stripped, lightly twist the ends of each wire to prevent them from
spreading apart. Repeat this process for all four exposed wire ends.
Attaching the Banana Adapters
Each adapter is color-coded to indicate positive and negative connections. The connector with the
red trim ring is typically used for the positive side, while the connector with the blue trim ring is
typically used for the negative side. Watch our Austere
on YouTube for a visual demonstration of how to attach the adapters to the speaker cable.
1 \\ Unscrew the gold-
plated connector of
each adapter.
Technical Support: Please contact our technical support team with installation questions,
troubleshooting needs, or general product questions.
• Phone: 1-855-672-0684
• Email:
2 \\ Slide one end of
the cable all the way
through the housing
of one of the banana
adapters until it stops.
Banana Adapter and Speaker Cable Video
3 \\ Evenly spread
the wires over the
self-crimping teeth.
4 \\ Replace the
connector and
securely fasten.
Repeat same steps for
all banana adapters.