Frigidaire 297298700 Panduan Penggunaan dan Perawatan - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Penggunaan dan Perawatan untuk Kulkas Frigidaire 297298700. Frigidaire 297298700 20 halaman. Frigidaire refrigerator use and care manual
Halaman Cetak
DOOR REMOVAL INSTRUCTIONS
Door Handle Mounting Instructions
1. Remove handle from carton and any other
protective packaging.
2. Position refrigerator handle end caps over upper
and lower pre-installed shoulder bolts (A) that
are fastened into door, ensuring the holes for the
set screws are facing towards the outside of door
if a single unit installation or the freezer door (if
installing the matching freezer)
3. While holding handle fi rmly against door, fasten
upper and lower Allen set screws (B) with supplied
Allen wrench.
4. Repeat steps 2 and 3 to install freezer handle
(if installing the matching freezer). Ensure the
holes for the set screws are facing towards the
refrigerator door.
NOTE
All set screws should be tightened and sub-fl ush (Allen
set screw should be seated just below the surface of
the end cap) of handle end cap. The end caps should
be drawn tight to refrigerator door with no gaps.
Kick Plate Removal
To remove the kick plate, use a Phillips head
screwdriver and remove the two screws holding the
kick plate to the cabinet. Then pull the kick plate
away from the unit.
Leveling
The refrigerator must have all bottom corners resting
fi rmly on a solid fl oor.
The fl oor must be strong enough to support a fully
loaded refrigerator.
It is VERY IMPORTANT for your refrigerator to be level
in order to function properly. If the refrigerator is not
leveled during installation, the door may be misaligned
and not close or seal properly, causing cooling, frost
or moisture problems.
Leveling instructions continued on next page.
6
A
B
Single Unit Installation
Matching Refrigerator and Freezer Door Handle
Installation
Kick Plate Removal
Remove Screws