ADE PWN5 Panduan Pengoperasian - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Timbangan ADE PWN5. ADE PWN5 12 halaman. Stainless steel scale for the food sector

ADE PWN5 Panduan Pengoperasian
3.7

Presetting the units

The various units such as "g", "lb", "lb:oz" and "oz" can be separately enabled or disabled as
needed.
To do this, press and hold down the [SET] button for 3 seconds until the display shows "SEt".
After releasing the button, the display will show "UNIT".
Now press the [SET] button. The display will show "g" as the unit of weight. Repeatedly press
the [UNIT] button to enable ("ON") or disable ("OFF") the unit.
Press the [SET] button to confirm the selection and switch to the "lb/oz" unit status display.
To enable or disable the unit selection, press the [UNIT] button and confirm the selection as
described above.
Perform these steps also for the "lb/oz1/8", "lb", "oz" and "oz1/8" units.
After confirmation of the last unit of weight to be selected, the display will show "UNIT".
3.8

Taring

There are two taring options: automatic taring when you turn on the scale and taring during the
weighing process.
With automatic taring, put the container to be tared on the scale before turning on the scale
and then turn on the scale. The display will show "0". As soon as you put the object to be
weighed into the container, only the net weight of the object to be weighed will be displayed.
This process can be repeated as often as desired until the maximum weight is reached.
If the scale is already turned on, taring will take place during the weighing process.
Put your empty container on the scale and press the [TARE] button. The scale display will
show "0". Now put the object to be weighed into the container. The scale now shows only the
net weight. This process can be repeated as often as desired until the maximum weight is
reached. Press the [SET] and [TARE] buttons at the same time to display the total weight. If
you remove the container and the objects to be weighed, the display will show the weight as a
negative value. Press the [TARE] button again to cancel the tare function.
If the display is not stable, the stability indicator will not light up.
3.9

Setting minimum and maximum values for checkweighing

It is possible to set the minimum and maximum values on the scale with an automatic playing
of an audible signal. It is very helpful if, for example, always the same filling quantities are
weighed.
Press and hold down the [TARE] button for 3 seconds to set the minimum and maximum
values for checkweighing. After a short beep, the "LOW" symbol will flash and switch back to
the "0" display. Now place the weight corresponding to the minimum weight on the weighing
platform and press the [SET] button to confirm. A beep will sound to confirm the stored
minimum value.
The "HIGH" symbol flashes now. Now add the corresponding weight to the minimum weight
until the desired maximum value is reached and press the [SET] button to confirm. A beep will
sound to confirm the stored maximum value.
Remove the weight from the weighing platform.
If you now place an arbitrary weight on the weighing surface, a beep will sound as long as the
applied weight is below or above the set values.
5
PWN5-191210-Rev005-UM-en