Agri-Fab 45-0354 Panduan Pemilik - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Peralatan Rumput dan Taman Agri-Fab 45-0354. Agri-Fab 45-0354 8 halaman. Grader blade
Halaman CetakASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
(2) 3/4" Wrenches
(1) 9/16" Wrench
(1) 1-5/16" Wrench or 12" Adjustable Wrench
(1) 1-1/2" Wrench or 14" Adjustable Wrench
(1) Pliers
CAUTION: THE BLADE SCRAPER AND
BL ADE AS SE M B L Y H AV E SH A R P
EDGES. USE CARE IN HANDLING AND
A S S E M B L Y . W E A R G L O V E S F O R
EXTRA PROTECTION AGAINST CUTS.
Remove all loose parts and the hardware package from
the shipping carton. Then lay out and identify each part
and the common hardware as shown on pages 2 and 3.
Be sure the carton is empty before it is discarded.
1. Assemble the blade scraper to the blade assembly
using seven 3/8" x 1" carriage bolts and seven
3/8" Nylock hex nuts. Tighten. See figure 1.
When installing the scraper to the blade assembly,
be sure the scraper is on the curved (dished) side
of the blade assembly and that the carriage bolts
are installed with the hex nuts on the back of the
blade assembly. Make sure all hex nuts are tight.
3/8" x 1"
CARRIAGE BOLT
FIGURE 1
BLADE
SCRAPER
BLADE
ASSEMBLY
3/8" NYLOCK
HEX NUT
2. Turn the mast assembly so that the cross brace is
at the bottom and the hole in the side of the mast
assembly is close to the bottom. Place the mast
assembly onto the threaded stud on the blade
assembly. Turn a 1" slotted hex nut down onto the
stud until it is snug. The cross brace should be in
front of the blade. See figure 2.
CROSS BRACE
AT BOTTOM
HOLE LOCATED
CLOSE TO BOTTOM
FIGURE 2
3. Back the slotted nut off until the first slot is aligned
with the hole in the threaded stud or until the mast
assembly can pivot on the blade assembly. Install
a cotter pin through the hole in the stud. Then
bend both ends of the cotter pin around the crown
of the nut to secure the pin and nut. See figure 3.
1" SLOTTED
HEX NUT
FIGURE 3
4
MAST
ASSEMBLY
1" SLOTTED
HEX NUT
BLADE
ASSEMBLY
COTTER PIN
STUD
HOLE