Cooke & Lewis 3663602842170 Manual - Halaman 4
Jelajahi secara online atau unduh pdf Manual untuk Kompor Cooke & Lewis 3663602842170. Cooke & Lewis 3663602842170 12 halaman.
Juga untuk Cooke & Lewis 3663602842170: Manual (20 halaman)
Halaman Cetak
Gas connection
WARNING: The connection of the hob to the gas network or gas cylinder must be made by means
of a rigid copper or steel pipe with fittings complying with local regulations. These fittings are NOT
supplied. THIS OPERATION MUST BE MADE BY A QUALIFIED GAS INSTALLER.
A connecting elbow is pre-fitted to the hob. This elbow terminates in an external 1/2" BSP connecting
thread complying with ISO 228-1:2003. The connection made to the pre-fitted elbow MUST be
suitable for connecting to this thread. If ANY other connection type or thread size is used a suitable
adaptor MUST be fitted.
The qualified gas installer must ensure that the operation of the burners has been correctly verified
before use.
CAUTION: The gas connection must be installed in compliance with applicable regulations in the
country of installation.
Gas supply requirements
The appliance installation must be carried out in accordance with relevant local regulations.
The installation must be carried out by an authorised gas appliance installer and tested to
local regulations.
We are not legally able to offer advice on the installation of gas appliances to
un-authorised personnel.
Ventilation
This appliance must not be connected to a combustion products evacuation device. It shall be
connected and installed in accordance with local installation regulations paying particular attention to
the relevant requirements regarding ventilation.
What to do if you smell gas?
Do not try to light any appliance.
Do not touch any electrical switch.
Do not use phones in the building.
Immediately call your gas supplier from a different property.
WARNING: Read the instructions before using the appliance.
THIS APPLIANCE MUST BE EARTHED.
THIS HOB MUST BE INSTALLED BY A QUALIFIED GAS TECHNICIAN!
Electrical connection
All installation must be carried out by a qualified electrician. Before connecting the mains supply
ensure that the mains voltage corresponds to the voltage on the rating plate.
Direct Connection
The appliance must be connected directly to the mains using an omnipolar circuit breaker with a
minimum opening of 3 mm between the contacts.
The installer must ensure that the correct electrical connection has been made and that it complies
with the wiring diagram.
The cable must not be bent or compressed.
TRAG10808 200000009 SM Cooke and Lewis 4 Burner Gas on Glass UK V2 R.indd 4
12/06/2017 13:35