4qd PRO-160-HC Buku Petunjuk - Halaman 2

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pengontrol 4qd PRO-160-HC. 4qd PRO-160-HC 16 halaman.
Juga untuk 4qd PRO-160-HC: Buku Petunjuk (16 halaman)

Halaman Cetak
1.

Introduction

The Pro-160 is an advanced digital PWM motor controller for currents up to 200A.
It uses a specialist microprocessor to control a full H-bridge design that does not
require relays for reversing. The display provides key information to the operator,
and can be mounted separately to the controller if required. It has a full range of
features and is very easy to configure if required.
2.

Do's and Don'ts

Warning – the Pro-160 does not have reverse polarity protection.
Connecting the battery wires incorrectly WILL destroy the controller.
Do
•
Do read the instructions fully
before installing.
•
Do take care to connect the
battery wires with the correct
polarity.
•
Do fit a motor suppression
capacitor, and ferrite rings.
•
Do twist the motor wires
together if possible.
•
Do call 4QD if you are
uncertain about something.
3.

Getting Started

•
Remove the four screws that hold the
cover to the end plates and lift off the
cover.
•
The Pro-160 is supplied with the keymat
ribbon cable not connected to its socket.
This should only be plugged in once the
Pro-160 has been fixed in position, the
control and power connections made, and
you are ready to start operation.
PRO-160 V2.3/2 04/20
Do not
•
Do not allow water to get onto
the circuit boards.
Page 2
www.4qd.co.uk