Cooke & Lewis CSS 1618 Panduan Perakitan - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Perakitan untuk Perabotan Dalam Ruangan Cooke & Lewis CSS 1618. Cooke & Lewis CSS 1618 2 halaman. Standard & tall dresser wall cabinets

Halaman Cetak
ASSEMBLY GUIDE
STEP 3:
Fit panel
to panels
and
, and tighten cams.
2
3
4
2
3
4
1
SMALL DRAWER FITTING
For fitting of drawers, refer to the assembly guide
within the drawer pack.
STANDARD & TALL DRESSER WALL CABINETS
FIXING TO WALL
Spacing between side panels
allow 20mm clearance each side
Measure
62mm from
top of unit
P
Position and secure fitting brackets
suitable fixings.
WARNING: There is a danger of this cabinet
falling off the wall if incorrectly fitted.
3
(Fixings are not supplied with the pack as they vary
according to the type of walls you have. If you are
Adjustment - IN & OUT to Wall
unsure, ask an expert).
Adjustment - UP & DOWN
Hang the cabinet onto the wall brackets
that the hooks are fully engaged behind the brackets,
as shown. (Pulling the fitted cabinet towards yourself,
whilst supporting its weight, will confirm this has
been achieved).
M
IN & OUT to Wall
UP & DOWN
Ensure the front face of the unit is vertical by using a
spirit level.
NOTES:
JOINING & LEVELLING
Mark 20mm on a 3mm dia. drill bit with masking
tape. Drill between the 2 holes drilled for the hinges,
through one cabinet side into the next, stopping when
P
you reach the marker.
Join the cabinets together with 2 x
to the wall with
P
90°
, ensuring
P
M
P
P
SHELF FITTING
Push shelf support
chosen shelf position holes,
4 per shelf.
Tilt and slide in shelf.
screws.
F
3mm
F
CSS 1618
07/15
into
J