CooKing SURFACE PRIME Buku Petunjuk - Halaman 7

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Kompor CooKing SURFACE PRIME. CooKing SURFACE PRIME 12 halaman.

Instructions for use

S U R F A C E

P R I M E

1. Turning on: Make sure that the main switch is set to "1". Press the on/off button on the remote control

to turn on the induction cooktop. The appliance will beep and the cooking zones will appear on the remote

control's LCD display. The cooktop will enter standby mode. To start cooking, choose one of the three co-

oking zones by pressing the corresponding circle on the display. The pot or pan will automatically start to

heat up. If a pot or pan is not present in the chosen cooking zone, the message "E1" will flash on the LCD

display and the cooktop will automatically switch off after 60 seconds.

2. Timer mode: the "Timer" button can be used to maintain a power level for a specified period of time. The

timer can be set after selecting the cooking zone and power level. Press the + or - button on the Timer once

and the LCD display will show 0:00 and the time will flash. Press + or - to increase or reduce the time setting

from 1 minute to 2 hours. After setting the timer, the LCD screen will display the remaining time and turn

off the cooktop at the end of the set period. If the time setting is 0, the timer function will turn off.

Note: hold down the + or - button for 3 seconds to increase or decrease the time from 10 minutes to 2

hours.

3. Lock mode: the "Lock" button can be used to keep the "power level" and "timer" functions locked at set

levels. Press the "Lock" button to activate this function when the system is in operation. The LCD display

will show the lock symbol "L". In Lock mode, no buttons other than the On/Off button and the Lock button

can be used. Hold down the "Lock" button again for 3 seconds to cancel the lock function.

4. High temperature indication function:

If the cooktop becomes excessively hot, the LCD display will read "H" (hot) and behave as follows in the

various modes:

a. During heating: the LCD display will read "H" without blinking. Heating will then stop and the LCD will

display the power level (from 1 to 6).

b. In standby mode: the LCD display will read "H" and blink continuously. It will disappear when the tempe-

rature falls.

c. In OFF mode: the LCD display will read "H" without blinking. It will disappear when the temperature falls.

5. Turning off: press the "On / Off" button to turn off the cooktop. The cooking zone heating process will

stop.

NB: Remember that induction cooking is very efficient and quick. Heat is generated directly and rapidly in

the bottom of the pan. For this reason, never place an empty saucepan in the cooking zone. Place the oil

or other cooking ingredients in the pan before you begin cooking and select the heating level according to

your requirements.

During cooking the pan must always remain in the centre of the cooking zone, otherwise the bottom of

the pan will heat unevenly and may result in burnt food and poor cooking quality. Check the pan constantly

while the oil is heating up to avoid overheating and the risk of burns.

The use of silicone trivets is essential when using pots and pans that are not part of the COOKWARE brand.