Austin Kontore Leopold Bench Kit Panduan Perakitan - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Perakitan untuk Penyimpanan Alat Austin Kontore Leopold Bench Kit. Austin Kontore Leopold Bench Kit 12 halaman. Children's version

Halaman Cetak

Attaching The Backrest

(1) 31" 2x8 Pine

Straight 90° cuts

Backrest

(4) 2 ½" Screws

Exterior Wood Glue

You will notice that the bench is a little flexible at this point. Installation of the Back will solve this.

Lay the bench on the ground or worktable.

Align the Back on the rear of the bench. The Back will be

flush to the top of the leg assemblies.

Make a pencil mark on both sides of the legs.

Remove the Back and apply thin layer of glue, going no

further than the line you just made.

Important: Construction adhesive does not stain, and

can be difficult to sand off. Try to avoid getting any on the

face (exposed surfaces) of the wood. Clean up excess right

away.

Realign the Back on top of the glue.

Important: Before putting the back in place, check to

see which side is most attractive. Have the nicer side

facing down. This is a good way to "hide" knots in the

wood. Don't worry about lumber grade marks—those can

be sanded off.

Page 10 of 12