Datron CruiseTV DBS-4500 Manual - Halaman 13
Jelajahi secara online atau unduh pdf Manual untuk Sistem Video Mobil Datron CruiseTV DBS-4500. Datron CruiseTV DBS-4500 18 halaman. In-motion satellite television system land version
Halaman Cetak6.1
Failure Messages
Failure messages are described in Table 2. If any of these messages are displayed, contact your
nearest Authorized Service Center or call Datron directly at (800) 287-5052.
Failure Messages Displayed
on Screen
CODE: 01 AZ & EL
CODE: 02 AZIDX
CODE: 03 ELIDX
CODE: 04 A2D
CODE: 05 XRATE
CODE: 06 YRATE
CODE: 07 ZRATE
CODE: 08 PLEVL
CODE: 09 RLEVL
CODE: 10 LNBFV
7.
Precautions
Do not open or remove any part of the antenna control unit or the antenna/radome assembly.
There are no user serviceable parts inside.
Operate the antenna system on a clean, continuous 12 VDC supply only. Fluctuations in voltage
can
degrade
performance.
CONNECTION.
To locate the authorized dealer nearest you, f you are in need of assistance, contact Datron/Transco
Inc. Customer Service Department at 1-800-287-5052.
Turn antenna system OFF after acquiring signal if vehicle is to be stationary for a long time. Power
off will reduce power drain and extend operating life of antenna and vehicle battery.
Table 2. Failure Messages
Reason for Message Display
Both AZ and EL index
switches/motors failed.
AZ index switch/motor failed.
EL index switch/motor failed.
Fault in the analog-to-digital
converter.
X gyro rate sensor failed.
Y gyro rate sensor failed.
Z gyro rate sensor failed.
Pitch level sensor failed.
Roll level sensor failed.
Failure of the R-hand/L-hand
polarity of the LNBF.
OBSERVE PROPER POLARITY ON THE POWER
M-01335, Rev. A
Possible Solution
Contact nearest Authorized
Service Center or call Datron
at (800) 287-5052
Repair or replace coax
Check receiver voltage to
LNBF
Page 11