ADE FL 98N Panduan Pengoperasian - Halaman 11
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Peralatan Dapur ADE FL 98N. ADE FL 98N 20 halaman.
Halaman Cetak
The machine must in no way be treated with a water jet or a steam pressure
cleaner!
Water must never be sprayed directly into the drive!
Removable parts must not be cleaned in a dishwasher as the surface
treatment may be destroyed.
Troubleshooting
The table below shows the main problems that may occur during operation.
FAULT
The motor does not rotate and
the worm shaft has stopped
The worm shaft does not
rotate
The running worm shaft makes
noise
Oil under the meat mincer
Storage and Transport Conditions
Keep all parts of the packaging in case you need to return the shipment to avoid possible damage
during transportation.
Warranty
ADE will repair or replace this product if it has failed within 1 year from the date of purchase (proof
of purchase is required) due to poor workmanship or defective material.
All moving parts, such as cables, cross blades, perforated discs, etc., are excluded from this
warranty. Warranty does not apply to normal appearance of usage or sign of wear or any damages
caused by accidents or misuse.
The warranty will not apply for devices that have been opened by unauthorised persons.
This warranty agreement does not affect the customer's legal rights in any manner.
The dealer from whom you purchased the machine is responsible for complaints.
Disposal
Waste electrical equipment do not belong in household waste. Please dispose
of defective or old devices according to the legal and country-specific
regulations!
FL-200128-Rev007-UM-en
CAUSES
Check whether the machine is
connected to the mains
Check whether the connection
of the three-phase plug +
ground + neutral is correct.
Foreign object in the mincing
section
The hand wheel is over-
tightened
The worm shaft is not latched
into the slot
Disc and blade are worn out
Possible leak in the oil seal of
the motor
REMEDY
Connect it to the mains
Ensure proper connection
Remove the foreign object
Slightly loosen the hand wheel
Insert the worm shaft correctly
Sharpen or replace the disc
and blade
Replace the oil seal of the
motor
10