AUSTRALIAN MONITOR AMHEAVYG Buku Petunjuk - Halaman 2

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mikrofon AUSTRALIAN MONITOR AMHEAVYG. AUSTRALIAN MONITOR AMHEAVYG 4 halaman. Heavy-duty gooseneck microphone
Juga untuk AUSTRALIAN MONITOR AMHEAVYG: Buku Petunjuk (2 halaman)

Halaman Cetak

INSTALLING YOUR AMHEAVYG MICROPHONE

Installing your Microphone

Choose a suitable flat surface to install the microphone.

Using a drill or spade bit drill a 5 mm hole in the surface to run the cable through.

Using a maker or punch and mark the position of the 3 holes in the microphone base.

Using suitable fasteners secure the microphone in place.

Wiring your microphone

The AMHEAVYG is shipped with an unterminated 5 wire cable. This allows the installer to customise the

connection type between the AMHEAVYG and device input.

The AM HEAVY provides a balanced microphone output signal. It also provides a normally open (N/O) dry

contact closure output from the momentary switch allowing connection to third party devices such as a

pre-announce tone generator.

Please follow the table below for successful wiring and operation of your microphone.

Audio Wiring Termination

Red wire

Black wire

Drain / Shield

Switch Wiring Termination

Green wire

White wire

(Normally Open (N/O)

PAGE 2

Audio Positive ( + )

Audio Negative ( - )

Audio Ground

Switch

AMHEAVYG HEAVY-DUTY GOOSENECK MICROPHONE