AUSTRALIAN MONITOR DIGIPAGE DP16M Informasi Layanan - Halaman 6

Jelajahi secara online atau unduh pdf Informasi Layanan untuk Mikrofon AUSTRALIAN MONITOR DIGIPAGE DP16M. AUSTRALIAN MONITOR DIGIPAGE DP16M 11 halaman.

Halaman Cetak

The CAT5 cable connects to the RJ45 socket on the rear panel of the

paging station. This socket is a NEUTRIKTM connector designed to be

used with the XLR style housing (model NE8MC) to improve reliability.

Normal RJ45 connectors can also be used.

Plugging and unplugging the cable while the system is powered up

may result in the system locking up and is not recommended. If this

should happen, reset the DigiPage by switching off, then on.

BASE PLATE SECTION

Voice Data

(shown as terminated)

DIGIPAGE8M/DIGIPAGE16M INSTALLATION & OPERATION MANUAL

INSTALLATION & SETUP

GAIN

To accommodate different speech levels, there is a gain control

on the base of the DigiPageM. This ships set to minimum and may

be adjusted to suit. Increasing this control too far may cause the

paging station to distort if loud or close speech levels are

encountered.

TERMINATING

In an RS485 network (of which the DigiPage is part of) it is

important to terminate the last device in the network CAT5 RUN.

Two jumpers are provided for the data transmission and the voice

transmission to be terminated if that Paging Station is at the end

of a CAT5 RUN (see diagram).Shipped as terminated.

Gain Pot

(accessible through base plate)

When making changes be sure to power off the

system and disconnect from the network.

NOTE: these stations are not compatible with the

DigiPageJr network system.

PAGE 5