AUSTRALIAN MONITOR ZONEMIX Panduan Memulai Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Peralatan Musik AUSTRALIAN MONITOR ZONEMIX. AUSTRALIAN MONITOR ZONEMIX 4 halaman.

Halaman Cetak

REAR PANEL

ACCESSORY PORTS

Allows connection of wall panel controllers,

paging stations and audio wall panel inputs.

See the full manual for wiring and setup

instructions.

ZONE OUTPUTS

The ZONEMIX4 has 4 stereo or 4 mono

balanced line level outputs (Software

configurable). The ZONEMIX8 has 8 mono line

balanced level outputs. Balanced male 3-pin

(3.81mm) euroblock connector.

STEREO RCA UNBALANCED INPUT

A standard stereo RCA female socket for each

input. This is summed to mono inside the

ZONEMIX8. The ZONEMIX4 will maintain the

stereo audio path unless mono output mode

is selected.

A -14dB pad can be applied, via software,

using the front panel or PC control software.

Off by default.

XLR MIC AND RCA LINE INPUT, CH1-2

A standard female XLR balanced socket is

provided on each microphone input:

Pin 1 = Signal Ground

Pin 2 = Hot (non-inverting or in phase)

Pin 3 = Cold (inverting or reverse phase)

MIC GAIN

Provides a rear panel attenuator for Input 1

and Input 2.

GENERAL PURPOSE INPUTS AND

OUTPUTS

Configurable in the PC control software to

perform various control actions.

TONE GENERATOR

Connect any of the EVAC, ALERT, INTRUDER,

BELL and CHIME inputs to the GND input to

play the tone.

RS232

3-pin (3.81mm) euroblock connector for

connection to external control systems.

ETHERNET

Ethernet is used to communicate with the

device over a LAN. The supported network

speed is 100Base-T.

Consult the Network setup section of the full

manual for further details.

POWER INPUT CONNECTOR

Your mixer is powered via a 24VDC 2A

universal power adapter. The power adapter

is included with your mixer. The DC input

accepts a 5.5/2.1mm plug with tip positive

and ring negative connection.